How to Set Up Eero Pro 6E

An Eero Pro 6E is a wonderful WiFi unit that supports the tri-band WiFi technology. It comes in a single, two, or three units pack thereby allowing you to improve the WiFi range in the house. The TrueMesh technology ensures that you have a fast and reliable internet experience and it lowers the latency rate at the same time. This post will explain you how to set up Eero Pro 6 in a few easy steps. Go on reading.

How to Install Eero Pro 6E?

The Eero Pro 6E unit comes with an Ethernet cable and a power adapter. Before starting the installation process, ensure that you have received every accessory in a good condition. Apart from this, you must know that you need to download Eero app on your mobile phone for the installation process. Also, your iOS devices should support minimum version 15.0 and Android devices should support 9.0. A cable or DSL modem is also required for the setup process. Now, walk through the steps given below to understand the installation process of the Eero.

1. Install the Eero App

Using Google Play Store or Apple App Store, download the Eero app.
Now, you need to get logged in to the app.

2. Log in to the App

For this, you will need the Amazon account details if you have one.
Otherwise, create an Eero account.
This will require your phone number and email address.
A verification code will be sent to your phone.
Use this code on the Eero app screen to complete the account creation process.

3. Set Up the Gateway Eero Pro

Now, set up the Eero Pro 6E gateway.
Unplug the modem from power and connect it to the Eero using an Ethernet cable.
Now, plug the modem back into the wall outlet.
Switch on the Eero too.
The Status light will start flashing white.
The next thing is to create the Eero network.
Once you tap Next in the app, it will start looking for your new Eero.
Enter the serial number of the router.
Select the location for your Eero by following the on-screen instructions.

4. Create the Network

Assign SSID and password to your Eero.
Add other Eero units to the home network.
The setup process is completed.

This is how you can set up the Eero Pro 6E mesh unit. The same steps can be followed for the Eero WiFi extender setup.

Take care of the placement of other Eeros. Ensure that you are keeping them in the central areas of your house. If there’s an internet dead spot in the house, you should keep it in the range of the Eero unit and the dead zone. Ensure that your Eero Pro units are neither too far nor too close. Do not place the WiFi unit in top, front, or under any device that emit electromagnetic waves or any object that contains a large amount of water.

Hardwiring Eero Pro 6E Units

This was all about how to set up Eero Pro 6E. It is expected that after following the instructions provided in the post, you will be able to install the router and add other units. Know that other Eeros can also be hardwired to each other. Just ensure that the cable is free of damages. Also, to improve the performance of the mesh system, keep the firmware updated.